Custom Intake Part 2

Custom Intake Part 2

ok this time im make the heat shield. i tried using a stock airbox and the pod filter wouldnt fit inside... (you can pry the stock aibox open. start from bottom side. they even have the prying hole ready)

so i had to make it from allumunium again... still got the left over from the cooling plate...

took about 1hour to do... i had to make custom bracket to hold the shield and put enough gap between the shield and the pod filter...

*those blue plastic around the rivet nail is the laminate protective cover for the allumunium... i forget to took that off before applying the rivet nail... lol... and now i cant be bothered peeling the leftover bits.... maybe later when i do the 3rd part....

i bent the front side bit to make some funnel effect... to force slightly larger volume to the pod filter...

this heat shield wont completely get rid of 'heat soak' nor that it will give any significance power gain... it will only help reduced it...

the next step is to make the hose that feed cold air to the intake...